Creality CR-10S filament sensor bracket for dual drive extruder

thingiverse

This is a bracket to hold the filament sensor in the creality CR-10S. It leaves the filament perfectly aligned using a dual drive extruder, as it is a bit taller than the stock plastic one. Other ones hold on to the two screws of the z-axis spindle, this one attaches in the back of the screw of the third z-axis wheel and bearing. I did this to prevent that two screws to being too tight because they must be a little bit loose. For installing, first you must check you have the same exact filament sensor because there are various types. Then trim it carefully like i show in the photos. Then you need a zip tie to secure it.