Creality CR-10S Z axis stop modification - end stop switch Spacer

thingiverse

This is an alternative modification to the CR-10S Z axis stop extender developped by Cymen On my CR-10S, the right hand side carriage was barely touching the right hand z-axis servo motor top mount. I move up the position of the end stop switch by 5mm, using like a spacer. Therefore, there is a little bit of increase in the bed height. Even with my cr10S with the original glass, I had this trouble of the side carriage touching the right hanf z-axis servo motor. You need to unscrew the end stop switch from its support and add 2 small screws M3 to mount it on the spacer. Then screw the spacer to the big support.