Creality CR-6 SE Filament Runout Sensor Riser for Dual Gear Extruder

cults3d

I upgraded my Creality CR-6 SE extruder to a dual gear unit from WINSINN that I purchased from Amazon. The same unit is sold under many different brand names. I tried to tag as many as I could. The new extruder is so much smoother and more reliable than the original part from Creality. It sits 10mm higher however, and the filament runout sensor will not align properly without modification. I created a simple riser with two m3 screw holes. I also remixed a gentler filament inlet for the filament runout sensor from L30Aero's design. You will need 2 m3x30mm screws to attach this to the stock mount points. Printed at 0.2mm layer height with 20% infill.