Creality CR10 Extruder for TPU with and without PTFE insert

thingiverse

There are four versions: 1. Platte (standard version, no insert needed for PLA/ABS etc.) 2. Platte PTFE (standard version with PTFE insert TPU/PLA/ABS etc.) 3. Platte + Kabel (with Kabelhalterung on the side, no insert needed, PLA/ABS etc.) 4. Platte PTFE+Kabel (with PTFE insert, with Kabelhalterung on the side, TPU/PLA/ABS etc.) I adjusted the Hole height to align perfectly. This version is better than the stock one even without printing with TPU. You'll see how easy it is to install your new filament. I use Option 4 because you can use it for all versions. You need a piece of PTFE Tube with an outer diameter of 4mm. You may need to widen the hole for the PTFE tube. Use a round file and make the tube a tight fit. 1. Screw in the PTFE Tube connector. 2. Place the PTFE Tube all the way in on the feeding side until it hits the end of the connector. Do not insert it into the side of the connector. 3. Cut the PTFE Tube along the radius of the part. I used a very sharp cutter. 4. Attach the part to your printer and check that the PTFE tube does not touch the Extruder gear.