Creality CR6 CR-6 SE Under-screen / Side Rail Raspberry Pi Model B 1 2 3 Case

thingiverse

I just extended the bottom. moved some of the side vent holes around and added rail brackets. This will fit a raspberry Pi model B 1, 2 or 3. It will fit into any rails that are the same as the CR-6 - but you may need different lengths of V-slot covers. I'd advise using a 10mm v-slot cover between the front of the rail and the raspberry pi case so it's not pressed right up against the metal screen bracket. If you're not using any wire clips - you can then use the 77mm v-slot cover behind it (or experiment as I did). I experimented with combining 10mm v-slot covers and this excellent 10mm rail cable clip to hold all my wires in place. https://www.thingiverse.com/thing:3625545 I ended up using some rail clips under the frame as well and usually used them to hold a single cable inside the clip and cable-tied another on top as I usually couldn't fit two wires inside the clip. I just printed in black PLA as it shouldn't get too hot. See my make for more and better photos.