Creality CR6 SE heatbed cable adapter rotate Strain Relief

thingiverse

09.05.21 Added a clip for the hole that the wire comes out of. Angles it up so the wire doesn't catch on the stepper motor. There isn't really a better solution without to route the cable a different way, or replacing the entire cable altogether for more clearance. Updated the mount so it clears the metal clip next to it. //----------------------------------------------------------------------------------------------------------// CR6 SE heatbed cable adapter rotator strain relief thing. Makes for more clearance in the back for enclosure or tight space. It's not a direct fit, the cables inside will need to be pulled out a little from the outside sleeve. The heatbed cable is short and may extend just enough to when the bed is all the way forward. It's recommended to inspect the length of the cable from the mainboard, and add additional cable length if needed. Also, cable may catch on the Y axis stepper motor when fully rotated to 90 degrees. A cover may be needed to let it slide over. Printing: high temp material petg, abs, nylon. Full print with 2-3x4x4 walls/top/bottom and 20%- infill. Remixes are welcome, also suggestions as well. Also, DO AT YOUR OWN RISK! May cause damage to circuitry, and the early model CR6 se has an issue with the heatbed wiring shorting on the ground cable. Make sure you know what you are doing before adding this mod.