Creality Ender 3 Raspberry Pi 3 Station, Bridge 4 Badge

thingiverse

Essentially the same thing as Hesi-Re's original model. The left side has been extended to go all the way down to the base of the aluminum leg, rather than stopping at the top. I included a 19mm x 9mm square in that side as well to allow you to pass the LCD cable through that side. The right side has had the power button hole removed and replaced with the badge of Bridge 4 (for any Stormlight Archive fans out there). The supporting pieces around the fan have been adjusted as well, so no supports should be needed there. The tolerances for the fit of the Raspberry Pi 3 were way too tight for me, in fact I ended up bending my board a bit getting it out of there. So I have made the wall around the Pi3 connectors just a bit shallower, and while it's still a good fit, I no longer worry about bending the board when I remove it or install it. Finally, I have included a blank version that is identical, except the Bridge 4 badge is not there (the power button hole remains closed).