Creality Ender Filament Guide Wheel

grabcad

UPDATED: 12 Sept 19, widened the wheel by 2mm and added the filament guide option.Parts List:2 x M4 x 16mm screw1 x 608 bearingM4 x 25mm (8-32 x 1") for use with filament hole guide.-Added a filament guide that mounts outside the wheel mount, this is not really needed but in the event you have a larger critical unattended build and want to ensure minimal possibility of the filament derailing, this is a good addition. Use a M4 x 25mm (8-32 x 1") screw in place of the 16mm screw.-Be sure to clean up the axle sections that rest inside the bearing so that it can be tightened so there is no wiggle or play in the wheel. -Increased the original wheel width by 1mm on each side.-Using the larger diameter wheel and smooth bearing movement, this works very well.-This was done in three parts so if you don't use the Creality version you are able to build your own base to adapt to the wheel and wheel mount for your printer.