Creality Ender3 Playstation Eye Mount

thingiverse

This is a remix. I really liked the original design but it took so long to print almost 10 hours as it needed supports all over. I thought if I could get this on the bed a different way I could reduce the print time. I managed to get it on the angle and it worked printed in 3 hours. But the hook did not print correctly. So I found that I needed just some supports and just on the hook so I found that adding in Custom Supports I could just add supports to the hook and that did the trick just a few supports for the hook and it was perfect. Don't forget to make sure you set just the hook area to 100% infill for strength. I saved both files from Cura with these settings so hopefully you are good to go. Note that block you see is there because this is how you get the per model settings so that you can print just the hook area at 100% infill while the rest of the model is set to 20%. That block will not actually print as the Mesh Type is set for "Modify Settings for Overlaps" this allows you to set this overlap area to 100% while it does not actually print the block you see. My pics show the final prints.