Creality Ender3 V2 Rotating LCD Control Mount

thingiverse

The Ender3 V2 control/display is nice, but the viewing angle makes it hard to use depending on your position in front of it. Sad that they didn't create any crystal rotate function for its viewing angle. So, These three parts mount to the t-slot frame using the three M4 screws and insert t-nuts that came with the V2 and use the control/display without any modification... it slides and locks in the same way the factory mount works. * The mounting plate has four attachment holes and it's Ok to use just three: the top two and either hole for the bottom mounting. I also moved the mount as far forward as possible before tightening it so the display doesn't interfere with the z-axis after auto-homing in the extreme up angle position. * The assembly uses an M4 x 45mm (or longer) is ok since the knob is very long. A pan-head screw (for the pivot & lock) has been ground to a "D" shaped head to keep it from rotating. The screw I chose was a philips head with the head outside diameter of 8.13mm (0.32") prior to grinding. I used a bench grinder to make the flat face on the side of the head that just barely touches the out edge of the threads. ( you can do this with a file, but it takes longer ) * I used a single M3 nut inside the adjustment knob. The nut used in the design was 7.11mm across it "flats" and 8.21 "point to point." So, one new M4x45 screw and matching nut with three printed parts and your display with tilt as you desire. Please like my design if you chose to download it.