Cross Trainer Tablet Stand

thingiverse

I wanted to watch stuff on my ipad while on the cross trainer, so I made this stand to fit it! This is a super specific thing but maybe someone can use it. The cross trainer is a Domyos Essentials one: http://www.decathlon.co.uk/essential-cross-trainer-id_8349406.html I also took advantage of the full size of the bed of the Robox 3D printer. Positioned diagonally this just fits, then the stand is held in place by the end caps on the cross trainer arms and the pressure from the foam covering. There are also round rings that could be attached to avoid the end caps sitting at an angle that I didn't end up using. I laser cut the front and back in 3mm acrylic and superglued them into the slots. I actually had to spend some time widening the slots for these pieces by hand so it might be good to print them a bit wider. I went for 3.1mm, probably something like 3.4 would be better depending on the printer. Print Settings Printer: Automaker Robox Rafts: No Supports: No Resolution: Medium Infill: 20% Notes: Position with the flat face down to get the nice curvy bit on top