Crusader GT2 200 SJCAM M10+ and RX Antenna Holder

thingiverse

If you call a Diatone Crusader GT2 and a SJCAM M10+ your own then you're right here! This little boxy mount gives you a nice and clean way to mount your M10+ with just two cable ties on top of the hood of the GT2. The 6 Blocks on the underside of the part have a snuggly fit in the slots of one of the top plates delivered with the GT2, so its a really tight and strong fit with a really low weight. On the back of this "backpack" I added two 4.2 mm holes to stick some PTFE tube I had layin around in for the RX antennas - (in my case its an frSky d4r II, but anyone with 2 antennas should fit, if you can tape it under the hood). There are also two lugs on each side with a perfect fit for one of the Diatone velcro straps, also delivered with the GT2, so you can really easily strap your cam on the mount. Right now this mount adds 7° to the angle of the hood, so its not the highest angle overall, maybe around 20°-ish. You can send me a comment and I will make some different angled versions, or a gopro session fit, or without the rx antenna holder, or.. or.. or.. you name it. Any comments, tips, hates, whatever are really appreciated, thank you! Print Settings Printer: Tevo Tarantula Rafts: No Supports: Yes Resolution: 0.2 mm Infill: 30% Notes: The 6 Blocks are the only thing on the printplate, so you have to print a really good support structure under it, so it prints well. I used Simplify 3D with 40% support infill and it did quite well.