CTC Sunken LCD Bezel

thingiverse

I liked robomodell's LCD bezel, but it didn't fit my printer right, and the LCD was a bit too high for my viewing angle (I sit with eye-level about the same height as the printer and the top line was a little cut off) So I re-mixed it to fix the issues that I had (the holes didn't line up on my CTC Dual and the LCD was too high in the mount). I also tapered the sides in a bit to allow for a wider viewing angle. I did not use the front bezel, so it's not included in my re-mix. NOTE The bottom cover plate needs to be notched out to clear the LCD, which sits about 15mm lower than before. See pics for details. Print Settings Printer: CTC Dual Rafts: No Supports: No Resolution: .25mm Infill: 50% Notes: Print with 3 or 4 shells to make the mounting holes strong enough to hold the screw threads. You have to notch the lower cover to clear the LCD as it sticks out quite a bit more than the 'stock' mounting directly on the front of the printer. (See last pic)