Custom Dinobot "SNAP" For Power Of The Primes "SLAG"

thingiverse

Meet "SNAP" the Allosaurus! Made to fit onto a chop-jobbed Power of the Primes "Slug". You'll need to remove the pin that connects the back of the head/jaw to the figure. Save this pin because you'll need it later. (You can knock it out by putting a brad nail against it and tapping with a hammer, or use a nail set if you've got one.) Also you will have to cut off the clear-plastic/gold parts from the tail; make sure you don't damage the grey plastic pins that those parts hook onto. (There will be pins left behind, don't bother trying to take them out because you won't see them afterwards.) FInally, you'll need to cut a couple holes into the figure's chest to mount the arm pegs. These should be right at the front of the red part of the chest, where the two "greebly" notches on Slug's shoulders end. (You might want to hold off on this until you've got all the parts printed and have a better idea of where these need to go.) Print and clean your parts, then assemble. Do some dry-fits first to make sure everything goes the way it ought. Assemble the arms by pinning the arms into the arm pegs using some 5mm rod; if you're fancy you can try to rivet them in or flare out tube stock to make a firmer connection. Then glue the tabs from the arm pegs into the chest holes. After this, put the head together. The bot head should just slip-fit onto the peg of the bot head plate, and then you can re-use the pin you removed earlier to fit in the dino head and the bot head plate. The tail has a cylinder part that should just slip over the gray peg that was left when you cut Slug's original tail off. My TFW2005 thread: <http://www.tfw2005.com/boards/threads/snap-allosaurus-custom-from-potp-slug.1158224/>