Customizable Cabinet Pull Jig Type 3 (Imperial)

thingiverse

This is a jig for drilling holes into cabinet doors and drawers for the pulls/knobs. It is best used with a clamp to hold it in place as you drill. Use in one direction for doors and flip it over to use for drawers. The default hole diameter setting is sized for a 3/16" drill bit, which is typically used to install the #8-32 screws that come with drawer pulls. The lines across the device are Center-Lines to help align the jig when drilling out holes on drawers. Print Settings Rafts: No Supports: No Notes: No supports or rafts required. I suggest using 3 shells so that the drill guide holes are more robust and don't wear out too quickly. I also suggest a minimum of 20% infill density so that the surface being pressed against the cabinet doors is as smooth as possible. A low density will require farther bridging, which usually leads to some sharp imperfections on the surface.