Customizable F2 Snowboard Binding Lift/Cant Shims

thingiverse

With this design, it is possible to customize and print your own F2 Binding shims for F2 Race/Intec Titanium and Intec Titanflex bindings. Customizable size (S, M, L), Lift Angle, Cant Angle and Base Depth are possible. Layout can also be specified - whether to layout as will be printed, or layout to preview how the shims would sit relative to the bindings. (Layout should be set to "Print" to actually generate the STL file for printing, otherwise the end result is not likely to be acceptable.) Recommend printing these in a material suitable for the intended environment in which they'd be used, for the sake of durability, non-brittleness and moisture/temperature tolerance. Recommend a high infill level for the sake of strength. Also recommend a 'shells' setting such that that the vertical walls are printed 100% solid. Some post-printing clean-up of the holes (drill), groove and ridge (file) will likely be required to get a good fit on the bindings. This is a somewhat complex design, and the Customizer will likely take several minutes to render under the best of circumstances. It may also time out before rendering is complete - if so, try refreshing the page, and/or changing a parameter to force a restart of the rendering process. If the Customizer is not responsive, the .scad file may be downloaded and used with OpenSCAD to directly manipulate parameters and generate an STL file. (The .scad file is also available at: https://bitbucket.org/jim_stoll/f2-binding-lift-cant-shims) Snowboarding is an inherently dangerous activity, with significant risk of damage, injury or death, including due to equipment failure. Modification of equipment can greatly increase these risks. Use of this design is entirely at your own peril. I accept no liability for any consequential loss, damage or expense of any kind arising from, or in consequence of, any fault or defect of any nature whatsoever in this design or its use. I can accept no liability for death, injury, loss or damage of any kind whatsoever whether to person or property however caused, arising out of or in connection with the use of this design. I accept no liability in respect of loss or damage to third parties caused directly or indirectly by use of this design. Current version: 0.1.0