Customizable Phone Dock

thingiverse

I needed a phone stand that could charge my phone overnight and let me pick it up in the morning to unplug easily. I looked around but most designs with a captive charging cable don't account for cases, and many are specific to one phone model. I made it highly customizable so you can adjust it to fit your needs. You can further customize it if you want to! Here are some things that will stay the same no matter what: * The plug is always centered at the bottom edge of the phone * The slot for the cable always goes all the way through the base * The thickness of the base is the same as the body * The base extends so the top of the body is centered on it * The phone covering section has both back and sides, but you can eliminate it altogether if you want to * The corners are rounded with a radius equal to the thickness of the body I've included two extra SCAD files that block off parts of the geometry. One for sizing the plug, and one for sizing the phone. I used these to print a few versions before spending time on the full print. Customizer variables: * Plug Measurements: + Plug Interface Depth: thickness of charging tip + Plug Interface Width: width of charging tip + Plug Interface Height: length of charging tip + Plug Width: width of plug block + Plug Depth: depth of plug block + Plug Height: height of plug block * Collar Measurements: + Collar Diameter: diameter of collar + Collar Height: height of collar + Cord Diameter: diameter of cord * Stand Measurements: + Phone Covering Height: height of slot that phone slides into + Stand Thickness: thickness of wall enclosing the phone + Stand Lip: how far wall covers face of the phone + Tilt Angle: how far phone should be tilted back from straight up when on dock