Customizable Pipe Stand (fusion360)

thingiverse

This is the pipe stand. You can use it to make towel racks, umbrella racks, door handles, and more. It can handle various pipe diameters.Customization is done by changing the parameters of fusion360 file (.f3d). Even if you're not using fusion360 right now, it's easy to install fusion360 and change its parameters, so give it a try. youtube link... https://youtu.be/EOUKaXq_Xe0 [Features] -Customizable -Can be firmly fixed and prevents the rotation of the pipe -Easy to remove from the pipe -Easy to print(no support) [Design point] Designed so that when the bolt is tightened, the bolt is parallel to the pipe. This enabled stable tightening. [Bolt/Nut type to use] type: CAP bolt and Nut M3 - M6 bolt length: 1.3 times or more the outer diameter of the pipe. [Customizable parameters] -Inner diameter of pipe (min:10mm at M4, max: no limit) -Outer diameter of pipe -screw size (M3, M4 ,M5, M6 ) screws larger than M6 are also possible by manually setting the screw related parameters. -stand height -screw hole diameter [caution] -Do not use for heavy use. -Countersunk screws are not recommended as screws for fixing to walls. There is a high possibility that layer cracking will occur. It is recommended to use washers or use pan head screws. -The hole for the nut is designed tight. Completely remove any residue remaining in the holes. I think the fastest way to insert a nut into a hole is to use pliers. -Since the input value of the parameter is not verified in the fusion360, an error may occur. For example if you use a too large bolt for a small inner diameter pipe, it may break. ex. M4 to 9mm pipe. If an error occurs, click the OK button in the parameter change window, and then click the undo button to return. [revision] 2021/11/27(v4) -Added washers. -When the pipe diameter was small, some walls were thin and weak, so I modified this to increase the strength a little. 2021/11/20(v3.2) Fixed a bug that occurred when pipe_od was increased. 2021/11/19(v3.1) Corrected that the angle of the arm angle was the opposite of plus and minus. 2021/11/19(v3) The angle of the arm can be set separately for the left and right. In addition, a negative value was also valid. 2021/11/18(v2) The angle of the arm can be changed by a parameter.