Customizable Wall Holder for double edge safety razors

thingiverse

This allows you to make a customized wall holder for safety razors, blades and shaving brushes. You have 7 spaces where you can fit a module in (less modules will shorten the overall length as opposed to leaving blanks) The first and last module will always be Razors as these provide the screw holes to mount to the wall, for each space in between you can then mix and match from the following: None - will put no module in that position and shorten the overall length. Shaving brush - holder for a shaving brush based upon typical dimensions. Additional Razor spaces - should you want to house your collection! Blade Holder - this is a space for either new or old blades, the design will also generate a half height and a full height used blade holder to fit in the space - you need to glue the lid onto the base. I had limited space so use a single blade holder slot for new and old blades - this is why the customizer should throw out 2 old blade box designs, one full height if you have space for 2 blade slots and 1 half height should you wish to use a single slot for new and old. Make sure the box for old blades (should you choose to print them) form properly and will not let sharp parts stick out of any printing gaps on the side, please also tape over the opening prior to disposal so that the blades not come loose in the trash.