CW-01 Tamiya Lunchbox, Midnight Pumpkin, Montero Wheelie Diff locker

thingiverse

This is a remix of Paul4x4Design's Clod Buster differential locker. To work with a CW-01 based chassis, there had to be some changes made. The hex nut slot is 10mm for a clod, 8mm for a cw-01 and also it is on the other side of the locker with the shaft sliding through. The shaft was also bigger on the clod, so it was reduced to 5.5mm for the CW-01. I was tired of my Lunchbox doing the wheelie wiggle and getting stuck in the sand, so I used my minimal design skills to fix the referenced design. The model fits extremely snug and for obvious reasons I would only recommend 100% infill. I printed in PLA and so far no issues. I had to use 2 small washers on each side of the shafts to prevent the idler gear from hitting the diff. The washers keep it centered very well.