[CyberBase System] Adjustable Tiers

cults3d

Inevitably, there's never enough space to put up and display your collection in their full glory. To avoid (or at least delay) this eventual tragedy, here's a set of adjustable tiers for to augment the CyberBase System to squeeze a bit more display space! Adding on to the base tile and pillars from the Core Set ( https://www.patreon.com/posts/38357788 ), these pieces snap on and provide adjustable shelf space without having to disassemble anything which has been setup. Shelves of 50mm and 75mm depth are provided to give ample room to place smaller titanmaster/micromaster class or legend/core class bots respectively. Optionally, there are 5mm ports on the shelves to allow for accessories and effect parts to be stored before these pesky small bits start to disappear. Everything is flush on the rear, to allow the entire setup to be flat against the wall or back of a shelf if needed. === Assembly=== Attached also is a labelled diagram showing all the parts of this set. A slightly improved pillar piece has been provided too, which should be a little more snug fitting than the earlier V2 piece. To assemble this setup, first notch the filler pieces into CBS pillars. By default, these will set the shelves to be 8cm above the base. But they can also be re-scaled vertically to set the shelves to be at different heights. Next, insert the clips in place, and finally slide in the shelf. With the shelf inserted, it should slightly 'lock' the clips in place and make for a stable tier. In fact, the lifter piece can be optional if your tolerances on the parts are good. From here, just arrange and display your bots to your heart's content! === Hope this helps solve (for a while!) the eternal problem of display space shortage and also give a more interest way to showcase your smaller bots! Happy 3d printing! =) === This model is not to be uploaded or sold in any form and is intended for personal use only. Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/) Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog