Cygolite Hotshot Mount

prusaprinters

<p>Stripped jmisavage's design for use with a simple L-bracket instead of having extra holes. I had to do a lot of post-processing with a file to get it to fit. Probably my own setup's fault. Kind of difficult to release the light, but again, probably my own setup.</p> <p>Imported STL back into SLDPRT, added the rear hex extrusion to support the inset hex head (8 mm size).</p> <h3>Post-Printing</h3> <p>Print it standing up to avoid supports in the channel areas. I needed a thin file to bring the channels to size. DISREGARD: see updates.</p> <h3>Updates</h3> <p>1 Feb 17: Yeah, don't print this standing up to avoid supports along the inside edges of the top "rails". The flexing necessary to release the light will break the mount in two.</p> Category: Replacement Parts