CZ 75 Grips

thingiverse

So I pecked around this file a little in my 3D software and made some changes. First I adjusted the fitment for CZ 75 pistols. The biggest difference is that I have drawn in some more fine tune rip away support structures so that the edges will all come out nicely, for a much better look and fit. Print Settings Rafts: No Supports: Doesn't Matter Resolution: 150 microns Infill: 80% Notes: High infill, 4 bottom layers. The multi color is done with a standard "hot swap"by pausing the print and changing the filament color. all the support structures you will need are drawn in, so keep support on or turn them off, it won't really effect the outcome of the grips. Recomend printing with ABS or other temp resistant filament. Post-Printing ARCH the grips IF YOU ARE PRINTING WITH ABS, after removal of the supports go ahead and throw each of the grips into boiling water for 30 seconds, take them out and use the heat to bend them into a mild arch. This will allow all edges of the grips to sync tightly to the firearm.