CZ Scorpion AK Style Safety

thingiverse

This is an AK-styled safety selector for the CZ Scorpion EVO 3. This selector was inspired by the "HB Industries AK style selector". This file should be printed so that the selector lies flat on the print bed surface (should require 180 flip). If the hole doesn't print at proper size ream it open with a .108 bit (or 1/8 although it'll be a bit loose). This is a work in progress. Any problems please let me know and I will address them as quickly as possible. Thank you! Change log: 1.01 - Relocated set screw to actually allow the safety to be installed (oops). 1.02 - Relocated screw hole again, angle was too sharp. This should be on the money. 1.03 - Relocated screw hole... again... This time angle was good, but was printing 2mm too high which caused delaminating and fitment issues. Also opened up hole to a slightly larger size to accommodate different printers. 1.04 - Some users reported the switch was sitting too close to the bump on the trigger pack so the higher was increased by 2mm, this should give good clearance on. Kept 1.3 if you prefer the closer feel. 1.05 - Added various left side versions. The left side of the CZ Scorpion has the bolt catch/release lever so I had a couple ideas on how to overcome this. These include the "stubby" which is chopped short. The "thin" which removes the bulkiness of the whole thing and makes it, well, thin. Third version is "mid support" which leaves that bulkiness in the middle, but allows the bolt catch to not interfere. Note: it is difficult to interact with the bolt catch while it is in the 'fire' position. I can't change this because this is how the AK Selector is meant to function since the AK does not have a bolt release (let alone a left side safety).