Da Vinci Jr (Junior) Fume Filter Holder

thingiverse

Fume Filter Holder to attach to the fan vent at the back of the Da Vinci Junior 3D Printer. Requires Carbon foam filter or similar to fit inside. UPDATE:- I have now created the filter holder and cap as two individual models so they can be printed on a 15cm size bed. I have also seperated the Grip Plug from the cap and flipped cap over so you can print it without support. Also corrected some other minor issues, so I would suggest only using V2 Files. I have just uploaded photos of my print at 0.3 layer height quality. Please do give me some feedback and upload any photos of prints I would be very interested to see. Instructions Print the main holder with support material, this should just be needed where the square cut out inside for the filter foam is. The cap and plug can be printed without support material. Once printed stick the unit to the back of the printer either with double sided tape, Duck Tape or SuperGlue (If you are feeling brave!). I may design a model with hooks for vent at the back at some point but this maybe a little tricky getting that right. Get your filter foam and cut it to the correct size for the square gap inside (I will get measurements for this at some point), and then push foam into place making sure it fills all the gap. Then glue your Grip plug into the filter cap, (Grip side sticking out and lip of cap sticking out also). and push fit the cap into place. You can then easily change over the filter when needed.