Da Vinci Printer 60mm dual fan cooler

thingiverse

A dual 60mm fan cooler for the Da Vinci 3d printer. it helps to solidify the print between layers and helps with overhangs while printing. When printing with PLA,this will help with the overhangs and can speed up your printing time. You could try it out on ABS but only turn on the fans after a good few layers have been set down on the heated bed. I use an external 12volt molex power supply to power the fans. Instructions i printed this in solid ABS and used two 60mm computer case fans rated at 0.28 amp mounted inside. i used a rubber band around the enclosure to make a tight fit and create an air seal. The power switch is rated at 12 volts 6 amp and measures 12mm X 19mm.