DAIGLE TH8A shifter mod

thingiverse

DAIGLE Thrustmaster TH8A shifter mod. Simple design using of 4 plunger screws carefully positioned to offer the best feeling. It also act as a short shifter, reducing the throw between gears. The design was thoroughly tested and shows no signs of wear after more than 10000km! What's needed : - 4 plunger screws m10x16 - 2 cable ties - tap m10x1.5 - white grease - blue loctite Prepare the part : Screws can be used to adjust strength. A good starting point is to let the screws stick out about 1mm. Apply white grease on the balls and blue loctite on the thread. Installation procedure (full pdf in attachment): 1- UNSCREW THE GEAR SHIFT KNOB 2- UNSCREW THE DESK MOUNT 3- REMOVE THE METALLIC SHELL a- Unscrew the 3 long screws. b- Unscrew the 6 short screws. 4- REMOVE THE INTERNAL MODULE c- Carefully disconnect the switch d- Partially unscrew the 2 side screws e- Unscrew the 4 screws connecting the module to the top of the gear shift lever f- Leave the original spring screw in place and make sure it maintains lateral tension in the gear shift lever (without over-tightening) 5- INSTALL THE NEW TH8A DAIGLE MOD g- Insert the part onto the gear shift lever h- Securely fasten the quick-release clips around the already installed part 6- REDO STEPS 5 TO 1 IN REVERSE ORDER