Darkroom Paper Safe

thingiverse

Tinkercad project: https://www.tinkercad.com/things/272BhPZRImf-copy-of-papersafe/edit?sharecode=tW7yIvYNPBQts51KCONeZHASsQ0p-1r5nH93cE_OCr8 - needs some supports for the finger tab (or remove it and print separately to make it fit on a Prusa Mini) - use a small wood screw to secure the parts one to another (it tends to work using just the "round fastening", but it's safer with a screw; after putting in screws, move the lid up and down a lot to make them easier to move) - I stuck a couple of coins in the front of the lid, near the finger tab, so that it closes by itself - glued some rubber feet on the bottom, so it doesn't move around - it was tested with paper, sitting in bright day room light, then used in the darkroom for a couple of months; worked fine - it was printed in black PLA with a 0.6mm nozzle and 0.4mm layer height, but anything should work