Dart Zone/Adventure Force Matrixfire Magazine Adapter

prusaprinters

<p>Update 16May2022-Added elastic version with more clearance, extended mag release, and detailed filler piece. &nbsp;Step files included</p><p>Update 25Mar2022-Removed lip which could occasionally catch AF waffles</p><p>Replaces the matrixfire hopper to allow it to feed magazines. &nbsp;Rewire the blaster to a 2s or 3s lipo for best results. &nbsp;If running on 3s, I recommend adding a PWM to control the speed of the feed wheel, since on full 3s it can burn grooves in darts.</p><p>Supports: Yes, but only necessary for the “nub” hanging over the right side. &nbsp;The elastic version uses sacrificial bridging to create the hole which can be cleared away after the print is complete.</p><p>Hardware:&nbsp;</p><p>Spring version: 2x ½" 4-40 screws and one appropriately sized extension spring (Captain slug style and sizing). &nbsp;I also used a variety pack from harbor freight.</p><p>Elastic version: 1x ¾" - 1 ½" 4-40 screw and about 4" of 3/32" elastic. &nbsp;Tie a knot in the end and feed it through the mag release end. &nbsp;Pull out through the top of the adapter, pull tight, and tie a second knot as close to the receiver as possible. &nbsp;Trim away excess</p>