Darth Maul Booknook with light up Sith Holocron design

cults3d

Star wars booknook In my photos i did not turn on the white LED's which makes Maul stand out more as i wanted to show the holocron reflection, you can see a video of the booknook lit up at night with LEDs: https://youtu.be/TKjnF9iOa_M The model is designed to be lit up with LED's 6 in total - two White in the back - to light MAUL when its night and 4 Red that goes into the roof light box. I wired the back and the roof lights seperately, so that you can turn on one or the other. Apart from the LEDS you will require a piece of Glass or acrylic, 3mm thickness. that is cut to 102 x 198 mm (10.2 x 19.8 cm). The Glass slides into the grooves cut on both the left and right walls - this goes infront of MAUL and reflects the Sith Holocron design directly around MAUL. I printed the walls (sides, back, roofbox) at 0.3 mm layer as there is not much details Darth Maul i printed at 0.1 as i wanted to have a lot of detail. the base with the writing i printed at 0.2 mm Darth Maul and the lightsaber WILL need SUPPORTS. which is why i separated Maul from the back wall (cutting a small recess as to glue him on in the correct place) allowing for fewer supports. The lightsaber is in two halves so as to fit it in his hand, one thing to be aware of when fitting this, it was designed that when maul it is placed in the box the lightsaber extends touching both sides of the box walls, if you push it into his hand too much it will be slightly short of touching the sides. The roof box i found that you need to paint the inside white, as this lights up entirely illuminating the Holocron. The model has 9 parts back base corner decorations Left wall Right wall Roof light box Roof box lid with holocron pattern Darth Maul Lightsaber