Darth Vader Melted Mask

thingiverse

I have been looking for a a really good Vader Mask and I found a couple but this is my favorite. The model had a few errors and I had the software fix them. I then positioned it a bit better for printing. Also I printed a few at a smaller scale and I suggest scaling down to 70% but thats up to you. One more thing I printed the model in the picture at 70% scale and a 5% infill (15% is suggested) and it was a 13+ hour print so a heads up. I must say that this requires supports and it is not for the novice at removing them as there are tons of crevices and cracks. I suggest small spring assisted needle nose pliers as well as a very small flat head screwdriver for getting in the small areas to remove the supports. Please take your time removing the supports and to double check the stl model to see where they need to be removed. The original designer had a hollow version which I may upload later but it is much tougher than this one to get right. With that said hope to see some awesome prints. The original was made by DIEGORIPP at: http://impression3d.laposte.fr/en/3d-model/art/darth-vader-melted-mask If you have questions or suggestions please visit his make.