DB2-W: 2in whoop FPV drone 95mm

thingiverse

##### Update2: I tried the build on a betafpv meteor85 frame but it didn't work well. My 1202.5 motors were too short and the props would hit the duct supports. I printed some spacers to fix that. I also had to cut the battery holder because my batteries didn't fit. After the build was together, it had a lot of flyaways on betaflight 4.3 both on default settings and after trying some whoop presets. I modified the design a little to make the ducts wider (vertically). This new design has been uploaded as v2. After seeing where the previous version broke, I think this will strengthen it quite a bit. I've had a few crashes in the yard so far and it hasn't broken. This 3d printed frame feels a lot stiffer than the meteor85 frame. It's also heavier, though. I've also switched from HDZero to walksnail in this build ##### Update: I crashed in the yard. This frame did not hold up too well. One of the spokes broke. It was fun to try to make, though. Probably better off just using a meteor85 frame. ----------------------- I wanted to try making a 2in whoop. This is the result. It feels pretty sturdy and hasn't broken from some light crashes in the house. It comes in at about 68g dry. Build: - DarwinFPV 15A AIO - RCINPOWER GTS V2 1202.5 11500kv motors - HDZero whoop lite vtx - HDZero nano v2 camera - ELRS EP2 receiver - Avan blur 2in props - 2s 550mah lipo