DCD Airsoft M4 Brick Battery Stock

cults3d

Demo Video: https://www.youtube.com/watch?v=HjhifgCWDqw This is a stock for M4 type airsoft guns, or any airsoft gun that uses a buffer tube. I designed this stock to accommodate large batteries for high capacity discharge brick type lipo batteries. It will hold a battery up to 114 x 34 x 25 mm in size, with a little bit of wiggle room. I specifically designed this for the Turnigy Bolt 3S 2400mah 65-130C but I only ever used the Gens Ace 3S 2200mah which is significantly smaller than the space available. The end plate slides on from the bottom and securely clicks in place. Its designed with tolerances for my printer obviously, but depending on your machine, filament and settings you may need to shim or sand part of the end plate or stock body for a perfect fit. Designed to print without supports and should work with any filament type - I've used PLA, PETG and CF-PETG. Hardware Required: 1x M4 Hex Nut (McMaster part 90592A090 or equivalent) 1x M4 x 10mm screw (McMaster part 91290A144 or equivalent)