Deathclaw (loading screen) feet stands

thingiverse

These stands are sized with indents to "hold" the feet of the loading screen deathclaw model (see remix link). They were made to hold the deathclaw model printed at 100% with 5%-50% infill (infill varying by the part); see print settings for more info. Print Settings Printer: Wombot Exilis XL Rafts: No Supports: No Resolution: Whatever; fine detail isn't needed. Infill: Again, whatever you feel is best. (I used 25%) Notes: These models are sized to hold the deathclaw model's feet at a very specific angle and at 100% scale - precisely. You will want to change the scale depending on the dimensions of your deathclaw model: I suggest increasing the size by about 2-3%, which should allow you to tilt the model a little way this way or that while still maintaining stability, and if you plan on gluing the model to the stand you can increase even more to allow a wider range of "stances" for your model. How I Designed This This was made using 123D Design; I created the stands and then "sunk" the entire model "into" each foot-stand, adjusting the deathclaw model's angle to what I thought looked best, and then using Combine-Subtract actions to "carve out" the feet-indents.