Deck and stairs lighting
thingiverse
Struggling with finding the right low voltage lighting solution for my stairs down to the lake, I printed this little unit which uses a T10 wedge type LED bulb (you can find a bunch of 12v types off of Ebay). I printed out of ABS it screws to the side of a deck or stairs. The back is open, so I recommend putting a piece of electrical tape over the hole in the back and hot glue over the leads coming out of the side to give a fairly good seal on the back. Instructions Print, insert the water proof T10 connector thru the back, hotglue wires to side, put a piece of wide blacktape over the hole in the back. Connect to low voltage wire with any number of connectors, I soldered to existing light connectors which were already attached that I cut off of existing lights. I used T10 rubber socket holders and 1 SMD Warm White Wedge LED lights.
With this file you will be able to print Deck and stairs lighting with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Deck and stairs lighting.