Dell Monitor Vesa Adaptor (S2x18, S2x19 monitors)

prusaprinters

<p>This print will allow you to use your Dell SE2419HR monitor with a VESA mount based monitor stand.</p> <p>This will be compatible with any Dell montor that uses the same metal pivot on the stand.</p> <p>To use:</p> <ul> <li>Detach base from existing monitor stand - twist screw on bottom of stand</li> <li>Detach existing stand from monitor - use a small screw driver to push in the hole at the top of the stand and slide down</li> <li>Disassemble the stand - it unclips apart easily then unscrew the two screws in the aluminium core</li> <li>Un-screw the steel pivot - its held by 3 M4 screws</li> <li>Use the "Bear technique" to capture M4 nuts in the 8 hex holes in the printed part - see <a href="https://guides.bear-lab.com/Guide/1.+Preflight+check+and+disassembly/34?lang=en">https://guides.bear-lab.com/Guide/1.+Preflight+check+and+disassembly/34?lang=en</a> step 2.</li> <li>Screw the steel pivot onto the printed part with 3 x M4x18mm cap screws </li> <li>mount the monitor :D</li> </ul> <h3>Print instructions</h3><p>Please use 0.2mm layer height for the hole bridges.<br/> I printed with the following settings for strength:</p> <ul> <li>6 top and bottom layers</li> <li>15 perimiters</li> <li>50% infill</li> </ul>