Delta PSU wire cover for Quick Connect

prusaprinters

<p>I like the quick disconnect add-on for the Original Prusa Enclosure, but didn't like the wires being bare (for aesthetic reasons). &nbsp;So I created this remix of the original Delta PSU wire cover that extends down over the back of the connector. &nbsp;The slits in the bottom where you can see the plug through are because of space limitations. &nbsp;If the bottom of the piece goes any lower, you can't get the PSU connected to the back of the case unless you put the PSU in first, then attach the cover. &nbsp;Didn't want that limitation.</p><p>&nbsp;</p><p>Also remixed a copy of the plug that was used to cover the quick disconnect hole to fill the old wire passthrough hole on the inside. &nbsp;so there isnt a random opening inside the case. &nbsp;To install it, before putting on the cover you slide it into the opening. &nbsp; The tab on it gets held in place by the cover when it is added.</p><p>&nbsp;</p><p>Printed in PETG with the following settings:</p><p>Layer height: 0.30</p><p>Infill: 15%</p><p>Infill Type: Grid</p>