Desk Mount Laptop Stand

prusaprinters

<p>Laptop stand designed for a 18.5cm thick desk and virtually any size laptop, yet still printable on a 230cm bed. Mounts with two screws on underside of desk.</p> <p>I sleeved this with cut road bicycle inner tubes over the upper mount forks to grip the laptop. Some sort of friction tape or similar is necessary for this design.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3 Pro</p></div> <p><strong>Rafts:</strong></p> <p>Yes</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>.24</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div> <p><strong>Filament:</strong> Hatchbox ABS Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>This design is bearing a lot of load with relatively little material so make it 100% solid.</p> I printed the top in 3d Solutech PLA and the bottom with the somewhat finicky [Hatchbox](https://www.amazon.com/s?k=hatchbox&amp;linkCode=ll2&amp;tag=thingiverse09-20&amp;linkId=f798b0df863f056fa470f03a65697ff4&amp;language=en_US&amp;ref_=as_li_ss_tl) ABS. I think it will work well with any material with good layer bonding. <p>I used 3 walls/shells. This caused it to tie the inner and outer walls in with infill which seems to strengthen it more.</p> <p>The base needs support everywhere, but it should be very low (5%) density to easily crush for removal because it wraps around.</p> <h3>Post-Printing</h3> <p><strong>Final steps</strong></p> <p>Bicycle inner tubes make a good grip, but so might other materials.</p> <p>Two lath screws attach it under the desk.</p> <p>Optional bolt through the hole helps secure the two pieces together.</p> </div></p></p></p> Category: Computer