Desk Stand for Panasonic WV-SW396 & WV-SW395 IP Camera

thingiverse

I needed to mount this ridiculous "web camera" on my desk, it has a 150mm dome, and I have a 140mm UP! printer. This is what I came up with, and amazingly it works quite well, and is fairly stable. Instructions I printed it on an UP! 140x140x135mm printer, which is why the base is curved. Otherwise it would try and overprint the 140mm perf board. If you have a similar printer, the STL file is actually a little to high, just scale it down in the Z dimension by 10%. (Press Scale, type in 0.9, then hit Z+. You'll have to turn it upside down before you print it, too. I printed mine with no raft, 0.40mm Z resolution, Normal quality, and a Hollow fill (for other folk, that's not literally hollow, but probably equiv. to something < 30% infill - guessing). It used 142.1 grams of ABS at any rate. The resulting print did have a little bit of bend in it, but was well up to the job.