Desktop Controller & Remote Holder -- REMIX

prusaprinters

<p>I needed a holder for my Xbox controller and some remotes (TV, soundbar, etc.). I found Jethro's model, but it was designed for an over-the-bed desk and required a screw to hold it in place. However, I really liked the controller holders that he designed, including the way they press-fit into the base.</p><p>I was OK hanging the holder off the side of a nightstand, but I did not want to screw it in place.</p><p>So, I remixed his holder to make it table-top stable (T-shaped). I also made one model with only one port for a controller. <strong>Refer to Jethro's model for the high &amp; low controller holders. Photos show both the high and low controller holders.</strong></p><p>Print settings:</p><ul><li>Ziro PLA Pro</li><li>6mm nozzle</li><li>0.3mm layer height</li><li>3 walls/perimeters</li><li>15% infill</li></ul>