Desktop Landscape display Ender3v2

thingiverse

Thanks to FredrikA for the source design. This is a simple desktop stand to use the Ender3v2 display in landscape mode, for example outside an enclosure. Not being mounted to anything, it moves around unless it's up against something. So I tend to use it in 'handheld mode' when I'm setting up a print. To do this you'll probably need a longer 10pin display cable, I found one on ebay, search for this.... 70CM 10 Pin USB ASP ISP JTAG AVR wire 10P IDC Flat Ribbon DATA Cable 2.54mm 2.3f Slicer tip - make sure to use at least 4 walls (or use 100% infill). And I used a couple of thin custom supports to help with the wide bridge near the top. Enjoy :)