Desktop Organizer - Split & Split again to print on a Mini

prusaprinters

<p>I liked the original design but I didn't have a need for a tower. Splitting them from a lower and upper section, adding a center cup and designed the bases for bearings.</p> <p>Only intended design was use for Prusament Spools, as I am going through too many per month, I will have an abundance shortly.</p> <h3>Print instructions</h3><p>Print Infill was the same as original design and all parts from the design were glued as original instructions.</p> <p>The bearings, bases and centers were all pressed to fit.</p> <p>Lower - The center cup has a relief to fit inside the center of the bearing , allowing independent movement, similar to a Lazy Susan.</p> <p>Upper - Brep was split adding a relief to one side filling the hollow gap are to be glued for assembly. Center cap has a relief to fit inside the center of the bearing and is just used to fill the hole of the spool.</p> <p>Bearing print came from here:<br/> <a href="https://www.thingiverse.com/thing:53451">https://www.thingiverse.com/thing:53451</a></p> <p>Printed at 99%:<br/> OD: 50.8mm x 14.8mm<br/> ID: 6.5mm</p> <p>This print may work as well, saw this afterwards <a href="https://www.prusaprinters.org/prints/11960">https://www.prusaprinters.org/prints/11960</a></p>