Desktop Smart Phone and Tablet Holder

thingiverse

My family keeps crowding my desk with phones, tablets, and kindles to be charged via USB - I needed a place to hold them out of the way while they do their thing. Created in OpenSCAD with detail level set high and using inches for measurement. Instructions This is a work in progress. I'm still doing my first few test prints. I suspect that for holding small devices it will print out easily enough on the makerbot replicator when positioned normally. One will just need to resize and place flat. However, to ensure that tablets can fit -- we'll need to build on its side. I tried to design so that it will not fall over, but we may need to enable support or something else to get this OK at the largest scale.