Dewalt ToughCase+ or Craftsman VersaStack Medium Case Parts

thingiverse

These are various parts to allow more advanced layouts of the DeWalt Toughcase+, Craftsman VersaStack, and Irwin compatible tool holders/cases. They were designed around the medium size case, but will fit the large cases as well. They should fit the small cases, but I do not have one to check. Included are dividers to allow placing the vertical bar off-center. They are named by the number of dovetails between the bar and the side of the case. A 1-wide divider will fit with the center bar in the second slot from the side, etc. Also included are full-length (bottom-to-top) vertical bars with dovetails in two heights. The center bar is a direct replacement for the supplied center bar, and will fit under the center lid divider. The other is a little taller, and will fit in any other slot in the box. There are also a variety of horizontal bars with dovetails, from a full-width bar down to a 3-wide bar. The dividers will work vertically with these bars. Finally, there are also small-parts containers with a solid bottom and cupped sides. I use this for small drill bits and hex keys that otherwise slip underneath the dividers. This is a work-in-progress. I will add parts as I get them designed.