DFC-2F

grabcad

DFC-2F- The heavy one. This cradle has a 1” mid-plate, DP, and front plate for those shows that require extreme pressure. The rest is made out of ½”. Compared to all of the other cradles the side bars turn into 1 piece, and the halo bars go from (4) pieces of ½” laminated to (2) pieces of 1” laminated. I personally do not like a cradle this heavy or expensive, but it has been asked for a lot. As always weld on a block, and with material this thick depending on if you are using laser or plasma you may have to clean some holes up a little more or grind a little bit to get parts to fit. Usually plasma likes a minimum of 1:1 hole size to material thickness, and with a smaller hole it will put a little more taper in it.