DHT11 Moisture Housing

thingiverse

This is a small housing I designed for the DHT11 to be used in reptile enclosures or anywhere there may be mist or moisture that lands on the DHT11. It's designed to be open to ambient air underneath but be close at the top and sides. the wires come down from the DHT11 and should be given about a 1cm loop before they come back up through the pass through at the back of the housing. This will allow any moisture that collects on the wires to flow down and drip off without reaching the DHT11. The housing is designed to be a bit oversized since there are many different sizes of breakout board made for the DHT sensors.