Diaper bin

thingiverse

Derived my Pen Holder (http://www.thingiverse.com/thing:26277, in turn derived from http://www.thingiverse.com/thing:12707), this diaper bin accurately fits a roll of plastic bags so you can refill it with an entire roll and just throw out the old ones when they are full (or smelly :-) Instructions Cut, assemble and glue the edges between the side and the bottoms. Notice that this design is optimized for wood, since acrylic probably does not bend that well. The first one I made was made with HDF, but the bends are a little too brittle. The round corners broke after a couple of months, while this (in birch plywood) has been in use since february without any problems... If you do not have a laser cutter wide enough, use the "short" files. You will need to cut two sides and the two bottoms. These files should fit even the smallest laser cutters (fits nicely into my VLS 2.30)...