Die Hard Christmas Ornament with light

thingiverse

I saw this elsewhere on Thingiverse and gave it a try. I ended up redesigning it to make it thinner to use less filament and also I put a hole in the bottom, so you could put in a christmas light where his lighter is. It really adds to the effect. It's an easy quick print with no supports. Steps after you print the box, just cover it with foil tape that you get at Home Depot in the paint section. After you do that, use a screwdriver to push through the hole to make a hole in the tape too. Print off the picture of McClane on Gloss photo paper. (I've included one so you could use that one.) The size for the photo is 5.5x2.5. This will nestle good in the back and with the foil, it will give a nice 3D look. To hang, I just use a ribbon and then attach it to each side using the same foil tape. Enjoy! And yes, it's a Christmas movie!