Digitech RP260 XP Wah Pedal Stopper/Spacer

thingiverse

Spacer to allow the wah pedal to be pressed without switching into volume mode. Sized so a hard press can switch modes. 72 mm between centre of bottom bumps. It's very easy on the pedal to accidentally switch modes between effects and volume, this prevents that. Printed it at 25% infill, and it had just enough flex to allow a hard press to still switch modes, but if you wanted to disable that, printing it at a higher infill with less flex would prevent that. As it is, I assume this will be a wearable part over time as it gets stepped on and slightly crushed each time. I have also included a version 1 that is thicker and presumably stronger. I did not print it, because it felt like it had extraneous material and I made it smaller so it would print faster as version 2.