Dinosaur World & Expansions Insert Remix

thingiverse

Slight Remix to try to eliminate the lid lift from zosocoheed's Dinosaur World Insert. [See my before and after pictures]. Please refer to zosocoheed's design for all the orginal files. https://www.thingiverse.com/thing:5059410/files For the most part all I did was remove 4mm from everything that I had on the top level of the insert. Here is a list of the parts I modified: Coin_and_danger_divider: I printed one as is (from zosocoheed), and then modified one to be 4mm shorter.) Card_Holder: Again I made this 4mm shorter. I also took out the center divider. This allowed the cards to sit at and slight angle which made them sit lower in the box. I took out the solo cards and stored them in the "Additional_token_tray". Additional_token_tray: I just took off 4mm (and as stated above I now store the solo cards here). Dinoworld_Dino_Playermat_Ends_x2 & Dinoworld_Dino_Playermat_Middle: For these I also took 4mm off, but I did it in my slicer, since that was the only modification that was needed.